|
Blade size |
Outer diameter: φ 405 - φ 1500 |
|
Pressing method |
The pressure bucket adopts the oil motor driven screw to raise and lower the preset height, and the pneumatic fast pressing on both sides can improve the pressing speed and safety |
|
Shaft seat guide |
Double linear slide track walking |
|
Feed mode |
1. Hydraulic cylinder controls feed 2. Servo motor controls feed |
|
Automatic function |
Realize continuous automatic sawing |
|
Lubrication device |
Advanced dry pulse micro spray and dust collection system |
|
Aluminum scrap recovery system |
Standard configuration |
The bearing is imported from Japan
The principle of aluminum chip recovery device uses the air inlet of centrifugal fan to generate high negative pressure, which is connected to the aluminum chip pipe mouth of the sawing machine through the feeding air pipe. After sawing, the aluminum chip is inhaled into the collection box under negative pressure. The spare chip is isolated by the intercepting and filtering cloth bag with added plate, so that all aluminum chips are collected into the box, and clean air will be discharged from the air outlet when the aluminum chips are collected to a certain extent, Open the door of the box and continue to use the aluminum peak in the whip collection box.
Copyright © 2019-2024 Foshan Jianeng Jingjin Aluminum Equipment Co,.Ltd. All Rights Reserved.
粤ICP备20068464号
粤公网安备 44060502002149号
Power by：
pbinfo.cn
